Heat And Fire Hazard; Op�Cal Radia�On Hazard; Notes On Moun�Ng - Derksen PHOS 15 indoor Nutzung

1.4. Heat and fire hazard

• Do not operate the unit near highly flammable sub-
stances, e.g. alcohol or gasoline.
• The projector may only be operated when mounted
securely and with the �lt of the projector head locked.
A descended projector or a projector head which has
dropped down can cause surfaces to catch fire.
• The projector's beam of light can reach high temperat-
ures at close range. Keep flammable materials at a safe
distance of 0.5 m / 1.6 � from the light exit point. This
distance increases the more projectors are used to illu-
minate a loca�on. Make sure to keep flammable ma-
terials (e.g. curtains) far away from the hazardous
area.
• The projector heats up during opera�on. Risk of burns!
Allow the projector to cool down for at least ten
minutes before changing a projec�on mo�f or per-
forming other tasks on the projector.
• The projector is cooled ac�vely or passively, depending
on its type, and requires an unobstructed flow of air
for cooling. Keep a minimum distance of 0.3 m / 1 �
from walls and objects on all sides.
• Do not cover the projector with shee�ng or insula�ng
material. Do not operate the projector in a closed cas-
ing. Effec�ve cooling is only possible if the discharged
warm air can escape and cool air can flow in freely.
• Protect the front lens from direct sunlight. Sunlight is
concentrated through the front lens and can cause
damage and fire inside the projector.
PHOS 15 indoor
Safety instruc�ons
1.5. Optical radiation hazard
According to the DIN EN 62471-5:2015 standard, the pro-
jector is classified in risk group 2 (RG-2) of the photobiolo-
gical hazard classes. To avoid the risk of glare from visible
op�cal radia�on, observe the following safety regula�ons:
• Do not stare directly into the light beam.
• Never look into the light beam at a short distance
(< 1 m / 3.3 �). Permanent eye injury may occur if you
expose yourself to the light beam within the hazardous
zone.
• Install the projector in a loca�on where a distance of
more than 1 m / 3.3 � can be kept from the eyes of
people exposed to the beam of light.
• Only change the projec�on mo�f (gobo) when the pro-
jector is switched off.
• Do not modify the op�cal components of the projector
(projec�on lens, other lenses, light source). Only use
original accessories and replace damaged components
only with original spare parts. A modified device may
be categorised into a higher photobiological risk group.
1.6. Notes on Mounting
The projector must be firmly a�ached to a stable and load-
bearing surface or structure.
Local regula�ons on the safety of buildings, especially regu-
la�ons on places of assembly, must be observed:
• Building regula�ons of the federal states: Safety of
construc�on sites and buildings
• Regula�ons on places of assembly
• Regula�on on the construc�on and opera�on of spe-
cial buildings (Special Construc�on Regula�on)
17 / 44