Kenwood DNR992RVS Schnellstartanleitung Seite 22

Connection/Installation
Ñ
3-way speaker system setup
Subwoofer Preout
Mid Range Preout
Tweeter Preout
When connecting to an external amplifier,
connect its ground wire to the car's chassis to
avoid damaging the unit.
Preout
RCA Cable
(Sold separately)
Power amplifier
(optional
accessory)
Input
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
NOTE
• For speaker system setup, see 3-way speaker
system setup (P.66) in the Instruction Manual.
• For speaker setup and crossover setup, see
Speaker / X'over setup (P.67) in the
Instruction Manual.
• For how to connect speaker wires to terminals
other than speaker terminals and Preout
terminals, see Connecting the system and
external components (P.22) and Connecting
wires to terminals (P.21).
22
Speaker
+
To mid range left
speaker
+
To mid range right
speaker
+
To tweeter left speaker
+
To tweeter right
speaker
Speaker impedance: 4-8 Ω
Ñ
Connecting the system and
external components
11 10
1
2
3
4
5
Connect to vehicle's steering remote harness.
1
Contact your KENWOOD dealer for details.
2
Accessory 3: Bluetooth Microphone
FM/AM antenna input
3
4 AV Audio output (ø3.5 mini jack)
When connecting to an external amplifier,
5
connect its ground wire to the car's chassis to
avoid damaging the unit.
Rear Audio Preout
(Left; White, Right; Red)
Front Audio Preout
(Left; White, Right; Red)
Subwoofer Preout
(Left; White, Right; Red)
6 External I/F
Maximum power supply current :
12 V = 500 mA
16
15
14
13
12
9 8 7
6