Installing The Main Unit - Kenwood DNR992RVS Schnellstartanleitung

Ñ
Microphone unit
1) Check the installation position of the
microphone (accessory 3).
2) Clean the installation surface.
3) Remove the separator of the microphone
(accessory 3), and stick the microphone to
the place shown below.
4) Wire the microphone cable up to the unit
with it secured at several positions using tape
or other desired method.
5) Adjust the direction of the microphone
(accessory 3) to the driver.
3
Fix a cable with a commercial item of tape.
Ñ

Installing the main unit

NOTE
• Determine the slider position before installing the
main unit. (P.17) The slider position cannot be
changed after installing to the vehicle.
• Make sure that the unit is installed securely in
place. If the unit is unstable, it may malfunction
(eg, the sound may skip).
1
Remove parts that interfere with
installing such as a panel on the vehicle.
2
Install the vehicle mounting bracket to
the main unit.
Vehicle mounting bracket*
Screw* (M5 × 8 mm)
3
Connect the wiring harness wires and
peripheral equipment.
4
5
6
7
Main unit
* Sold separately
Connection/Installation
Install the main unit to the vehicle.
Reinstall the removed parts such as a
panel on the vehicle.
Main unit
Install the display unit (accessory 6) to
the main unit.
NOTE
• If the display unit hits a panel on the vehicle,
adjust the display height by referring to
Adjusting the display height (P.18).
Fix the display unit with six hexagon head
screws (accessory 9).
9
Panel on the
vehicle
Main unit
6
19
English