Technical Data - HANSGROHE Ecostat E 15708 Serie Gebrauchsanleitung, Montageanleitung

Safety and Important Information
Hansgrohe products are safe provided they are in-
stalled, used and maintained in accordance with these
instructions and recornrnendations.
Please read these instructions thoroughly and retain for
future use.
The plumbing installation of this thermostat mixing valve-
must comply with the requirements of UK
Water Regulations/Bylaws (Scotland), Building Regula-
tions or any other regulations specified by the local
Water Authority and supplier.
The installation of thermostatic mixing valves must com-
ply with the requirements of the Water Supply (Water
Fittings) Regulations 1999.
We strongly recommend that you use a plumber regis-
tered with or a member of an Association:
Chartered Institute of Plumbing and Heating Engineer-
ing (CIPHE)
Water Industry Approved Plumber Scheme (WIAPS)
Dispose of plastic bags carefully
Keep children well away from the work area.
Check for hidden pipes and cables in the wall before
drilling holes.
The unit must be mounted on a finished waterproofed
wall surface (usually tiles).
If you are using power tools (e.g. to drill holes) wear
safety glasses and always disconnect tools from the
power supply after use.
Do not operate the shower unit if the hand shower or
spray hose has been damaged or is blocked.
Do not block the flow of water from the hand shower,
by placing it on your hand or any other part of your
body or foreign object.
The thermostatic unit should be serviced annually by a
qualified person to ensure maximum safety during use.
The thermostatic mixing valve will be installed in such
a position that maintenance of the TMV and its valves
and the commissioning and testing of the TMV can be
undertaken.
The mixer is fitted with check valves (page 72 pos.
92594000 / 97350000). There are filters on the ther-
mostatic element too (page 72 pos. 98282000).
The fitting of isolation valves is required (preferred loca-
tion page 75 Installation Requirements)
74
On the following pages 74 - 77 you can find important
information only for the installation in UK
Technical Hotline (for UK only)
Tel: 01372465655
Email: Technical@hansgrohe.co.uk
(Diese Servicehotline ist nur für das Vereinigte Königre-
ich Großbritannien, nicht z. B. für Deutschland)

Technical Data

This thermostatic valve will suit supplies of:
HIGH PRESSURE (HP-S)
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
Maximum outlet temperature:
Safety check:
Hot water connection:
Cold water connection:
Minimum difference between hot
water and mixed water temperature:
Hot and cold supply pressure should be balanced
Mixed water temperature
Application
Shower
Washbasin
Bath (44°C fill)
Bath (46°C fill)
*For preset outlet temperature adjustment –
See page 64.
NB. If a water supply is fed by gravity then the supply
pressure should be verified to ensure the conditions of
use are appropriate for the valve. Valves operating out-
side of these supply conditions cannot be guaranteed to
operate as a TMV2 or TMV3 valve.
Recommended outlet temperatures
The BuildCert TMV scheme recommends the following
set maximum mixed water outlet temperatures for use in
all premises:
44°C for bath fill but see notes below;
41°C for showers;
41°C for washbasins.
The mixed water temperatures must never exceed
46°C.
max. 10 bar
1 - 5 bar
16 bar
max. 70°C
65°C
26 l/min. @ 3 bar
43°C +/-*
40°C
Left hand
Right hand
6 K
Mixed water temperature
(at point of discharge).
41°C max.
41°C max.
44°C max.
46°C max.