Start-Up; Setting The Time - ADE CK 1706 Bedienungsanleitung

Start-up

NOTE on material damage
− Use only the supplied mains adapter.
You can also operate the radio alarm clock without a backup battery. It is not
possible to operate only with the battery without connecting to the mains.
In the event of a power outage, a 3 V CR2032 battery ensures that settings made
(e.g. alarm times) remain stored for several hours. Upon delivery, the backup battery
is already inserted and is provided with an iso strip to protect against premature
discharge.
1. Loosen the screw on the battery compartment cover on the underside using a fine
Phillips screwdriver.
2. Remove the battery compartment cover.
3. Pull out the iso-strips.
4. Replace the battery compartment cover and secure it in place using the fastening
screw.
5. Uncoil the FM wire antenna completely and attach the end as high as possible to a
wall or a shelf, with adhesive tape for example.
6. Insert the plug of the supplied mains adaptor into the 5V2A connection socket of
the radio alarm clock.
7. Plug the mains adaptor into a socket that has a voltage corresponding to that
described under "Technical Data".

Setting the time

If there is more than approx. 20 seconds between two pushes of a button,
the setting process automatically ends and you will have to repeat it.
Settings you have already made remain saved.
1. Use the 12H/24H button to select the desired display format for the time. If you
select 12H, morning hours will be marked with "AM" and afternoon hours with "PM".
2. Slide the switch to the left.
The display flashes.
3. Set the correct time by turning the multi-function knob:
- Turn counterclockwise: reduces values
- Turn clockwise: increases values
4. Finally, slide the
time.
Radio alarm clock CK 1706
switch to the right (lock icon) when you have set the correct
Start-up
31