Herunterladen Inhalt Inhalt Diese Seite drucken

Start-Up; Receiving The Time Signal - ADE CK 1710 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

Start-up

Start-up
To use the product, you need five 1.5 V batteries of the LR6 (AA) type.
1. Pull out the locking pin from the back of the clock completely. Otherwise the clock
hands are unable to turn.
2. Place the battery on the bottom of the battery compartment as shown. Pay
attention to the correct polarity (+/-).
Once the batteries are inserted, the clock switches to the receiving mode, see next
chapter.
The battery compartment is divided into two parts:
‚ The upper compartment (one battery) serves for the clock function
itself.
‚ The lower compartment (four batteries) serves for the night light
function.
Thus, you can operate the clock with a single battery in the upper battery
compartment. The night light function is unavailable in this case.
Notes on changing the battery:
‚ When the hands stop, batteries must be replaced.
‚ Only use the type of battery that is specified in the "Technical Data".
‚ Always exchange all of the batteries at the same time.
‚ Dispose of batteries in an environmentally appropriate way (see "Disposal").

Receiving the time signal

Shortly after the batteries have been inserted into the upper battery compartment, the
hands start turning and then indicate 12 o'clock. The radio wall clock then switches to
receiving mode.
As soon as the time signal has been received with sufficient strength, the hands begin
to turn again and then indicate the current time. This process can last a few minutes.
The radio wall clock switches immediately to receiving mode automatically several
times a day and compares its own time with that of the time signal transmitter. If there
is a difference, the time indicated by the clock will be automatically corrected.
If no sufficiently strong signal was received, the radio wall clock interrupts the receiving
process. In this case:
‚ First check whether the location of the radio wall clock is appropriate – see "Tips
for good reception".
‚ Remove the battery and reinsert it in order to start the receiving process again.
16
Radio Wall Clock CK 1710

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis