Startup / Operation - BOMANN WA 7185 Bedienungsanleitung, Garantie

• Connect the water inlet hose to a water thread
with ¾". Screw the hose firmly in the direction of
the screw thread; pay attention for a tight fit.
• Connect the other end of the inlet hose to the inlet
valve on the appliance back; pay attention for a
tight fit too.
Connect the water drain hose
NOTE:
The drain hose has a length of approx. 1.5 m and,
contrary to the recommendation, could be extended
to a maximum of 4 m with a suitable hose connector.
CAUTION:
To prevent backflow of contaminated water, the free
end of the hose must not come under the water level
of the drain.
• Connect the drain hose to a drain pipe with a
minimum diameter of 40 mm; alternatively, the
drain hose can be fixed to a sink or directly to the
drainage.
• Always make sure that the hose is not bent or
squeezed. For this purpose, use the delivered
hose retaining bend (a).
• The hose must be installed at a height of min.
700 mm and max. 1250 mm above the floor.
• Secure the hose securely to avoid a change in
position and with it a water leakage.
Electrical connection
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock!
• Do not use multiple sockets or extension cords.
• It is not allowed to modify the plug provided with
the appliance! If the plug does not fit properly to
the outlet, let install a proper outlet by an author-
ized specialist.
• The accessibility of the power plug must always
be ensured to disconnect the device from the
power supply in case of an emergency.
• Make sure that the voltage supply matches the
specifications on the rating label (appliance back)
before connecting.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.

Startup / operation

Prior using for the first time
• Make sure that all transport securing devices has
been removed.
• Remove the accessories and any material from
the drum.
• Allow the appliance to wash the first time without
any laundry, with the addition of some detergent
(approx. 30 ml) in the program [Drum Clean] (see
"Starting the program"
29
).