BOMANN WA 7185 Bedienungsanleitung, Garantie Seite 28

eled, adjust the feet accordingly (see
feet"
).
• Power cord and water hoses may not kinked or
squashed.
• The wall socket must be freely accessible.
• Avoid the installation:
- near heaters, next to a stove, direct sunlight or
any other heat sources;
at locations with high humidity (e. g. outdoors),
-
as metal parts would be susceptible to corro-
sion under such circumstances;
in rooms where the temperature could drop
-
below freezing. Do not expose the appliance
any weather.
- near volatile or flammable materials (e. g. gas,
fuel, alcohol, paint, etc.).
Adjusting the feet
CAUTION:
The feet must never be removed. Do not restrict the
floor clearance through carpets, strips of wood or
similar. Danger of heat accumulation!
• Use the supplied wrench to loosen the lock nuts.
• Rotate the feet to change the height.
• Tighten the lock nuts if the unit is aligned. The
feet must have solid ground contact.
• Check with a spirit level whether the appliance is
leveled horizontally. If the unit is not in balance,
the feet must be adjusted again.
"Adjust the
Installation under working plate
WARNING:
For reasons of electrical and mechanical safety, it is
not allowed to remove the appliance top!
Water connection
CAUTION:
• The Installation of the water supply must conform
to the local laws and regulations.
• The appliance is not suitable for hot water supply.
• Use the new supplied hose set to connect the
appliance to the water supply. Do not reuse old or
used connection sets.
• If the water pipe is new or long time not used,
ensure before connecting to the water system,
that the water is clear and free from contamina-
tion.
Notes on inlet hose safety system (delivery scope
depending on model)
The safety system consists of a double-walled inlet
hose. It guarantees to cut off the water supply when
leakage of the inner hose. Switching off the water
supply leads over an electronic contact.
If necessary, you can order an inlet hose safety sys-
tem from your dealer or in our online accessories
shop, www.bomann-germany.de. To order, use the
reference number found under
Connect the water inlet hose (cold water connection)
NOTE:
The water pressure must be between 0.1-1.0 MPa.
With higher pressure: use a pressure regulator.
28
The appliance can only be
positioned under a working
plate if the minimum dis-
tances can be adhered as
shown in the illustration.
"Technical Data"
.