Option Menu - Yamaha RX-V557 Bedienungsanleitung

Input rename
C)INPUT RENAME
Use this feature to change the name of the inputs in the
front panel display.
1
Press an input selector button to select the
input you want to change the name of.
2
Press AMP.
3
Press j / i to place the _ (under-bar) under
the space or the character you want to edit.
4
Press u / d to select the character you want,
then use j / i to move to the next space.
• You can use up to 8 characters for each input.
• Press d to change the character in the following
order, or press u to go in the reverse order:
A to Z, a space, 0 to 9, a space, a to z, a space,
symbols (#, *, –, +, etc.).
5
Repeat steps 1 through 4 to rename each
input.
6
To exit, press SET MENU when finished.

3 OPTION MENU

Use to adjust the optional system parameters.
Display settings
Dimmer DIMMER
Use to adjust the brightness of the front panel display.
Choices: –4 to 0
Video conversion V. CONV.
Use this feature to turn on/off conversion of composite
(VIDEO) signals to S-video signals. This allows you to
output converted video signals from the S VIDEO jacks
when no S-video or component signals are input. This
feature also converts S-video signals to component signals
when no component signals are input.
Choices: ON, OFF
• Select OFF not to convert any signals (except S-video
signals to composite signals).
• Select ON to convert composite signals to S-video and
component signals, and to convert S-video signals to
component signals.
• Regardless of the setting, S-video signals are always
converted to composite signals.
Notes
• Converted video signals are only output to the MONITOR OUT
jacks. When recording you must make the same type of video
connections (i.e., S-video) between each component.
• When converting composite video or S-video signals from a
VCR to component signals, the picture quality may suffer
depending on your VCR.
Memory guard B)MEMORY GUARD
Use this feature to prevent accidental changes to DSP
program parameter values and other system settings.
Choices: ON, OFF
Select ON to protect:
• DSP program parameters
• All SET MENU items
• All speaker levels
When "MEMORY GUARD" is set to ON, you cannot use
the test tone or select any other SET MENU items.
SET MENU
A)DISPLAY SET
53