Set Current Day And Time; Set On/Off Time And Temperature On A Weekly Cycle; Open Window Warning - Napoleon Allure Serie Installations- Und Betriebshandbuch

operating instructions
EN

4.3.1 set current day and time

1. Press
2. Press . When the hour digits begin flashing, use
3. Press again. When the minute digits begin flashing, use
4. Press

4.3.2 set ON/OFF time and temperature on a weekly cycle

1. Press . When "MON" begins flashing, press
select the desired hour and minute to turn on the heater. Press
and shut down "ON" timer.
note:
The timer can only be adjusted in 30-minute increments (i.e. 00:00 - 00:30; 00:30 - 01:00, etc.)
2. Press . When "OFF" begins flashing, use
heater. Press
3. Press again. When "18" begins flashing, use
note:
If the temperature was previously set, those digits will be shown instead of "18".
4. Press again. When "TUES" appears on the screen and "ON" begins flashing, use
desired hour and minute to turn on the heater for Tuesday.
5. Press again. When "OFF" begins flashing, use
the heater for Tuesday.
6. Press again. When "18" begins flashing, use
7. Repeat steps 1 to 6 to set the "ON/OFF" time and temperature for Wednesday, Thursday, Friday,
Saturday, and Sunday.
8. Press
in the middle of the appliance. The appliance will "beep" once to confirm that programming has been
successful.

4.3.3 open window warning

If the room temperature decreases by 10 degrees within 3 minutes, the appliance will assume there is an open
window nearby. In order to conserve energy, the heater will automatically switch from High Heat to Low Heat, or if
the heater is already at Low Heat, it will turn off completely.
When switching from High Heat to Low Heat, the appliance will beep 3 times and the digital display will flash "88"
3 times before displaying the existing heating status.
When switching from Low Heat to Off, the appliance will beep 3 times and the digital display will flash "88"
continuously.
To reset the heating function, see "operating remote control" section.
20
W415-1699 / F / 10.29.21
once. When "MON" (Monday) begins flashing, use
again. The current time is now set.
at any time to clear the digits and shut down "OFF" timer.
or to complete programming, ensuring to aim the remote control at the receiver, located
to select the current day.
to select the current hour.
to select the current minute.
3 times. When "ON" begins flashing, use
at any time to clear the digits
to select the desired hour and minute to turn off the
to select the desired temperature for Monday.
to select the desired hour and minute to turn off
to select the desired temperature for Tuesday.
to
to select the