Installing The Appliance - Napoleon Allure Serie Installations- Und Betriebshandbuch

2.4

installing the appliance

Due to the many different materials used on different walls, it is highly
recommended to consult your local builder before installing this
appliance on the wall.
Select a location that is not prone to moisture and is located at least
A.
36" (91.4cm) away from combustible materials such as curtain drapes,
furniture, bedding, paper, etc.
Have 2 people hold the appliance against the wall to determine the fi nal
B.
location.
Place appliance face down on a soft, non abrasive surface. Remove the
C.
bracket from the back of the appliance by removing the screws (Fig. 1
and 2).
Mark out location, then mount the bracket(s) onto the wall using the supplied screws. This bracket MUST
D.
have the hooks facing upward and be level.
note:
It is strongly recommended that the mounting bracket be screwed into the wall studs where possible. If the wall
studs cannot be used, ensure that the supplied plastic anchors are used to affi x the bracket to the wall and the
bracket is adequately secured.
With the wall mounting bracket
E.
installed, have 2 people lift the
appliance up and insert the 2
hooks on the bracket into the 2
slots on the back of the appliance.
Check the appliance for stability
F.
ensuring that the bracket will not
pull free from the wall.
Fig. 2
BRACKET
Fig. 1
NEFL32/42/50FH-EU Bracket Illustrated
NEFL60/72/100FH-EU Bracket Illustrated
installation
EN
11
W415-1699 / F / 10.29.21