Front Glass Installation - Napoleon Allure Serie Installations- Und Betriebshandbuch

3.0 fi nishing
fi nishing
EN
WARNING
!
• Power supply service must be completed prior to fi nishing to avoid reconstruction.
• Heat vents and air openings cannot be covered in any circumstances.
3.1

front glass installation

• Glass may be hot. Do not touch glass until cooled.
• If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
• Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
• Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
A. Before installing the front glass, remove the screws securing the paper board on the inside of the
appliance that protects the control panel. Discard the paper board.
Reinstall the screws (for recessed-installed appliances only) (Fig. 1).
B.
Remove the 2 screws from the top of the appliance.
C.
Have 2 people lift the glass up and away from the appliance, holding the glass vertical - not fl at - while
D.
carrying. Place the glass face down onto a soft, non-abrasive surface, being careful not to fl ex the glass.
Bend the top tabs fl at (Fig. 2).
E.
Install the crystal embers (see "crystal ember installation" section).
F.
Install the front glass by aligning with the pins on the appliance. Press the glass in and down to securely
G.
engage with the brackets. It must be fully engaged to ensure the touch display panel performs properly.
Secure the front glass using the screws provided to the top of the appliance (Fig. 3, next page). If
H.
appliance is fully recessed, this is not necessary.
Fig. 1
Fig. 2
16
W415-1699 / F / 10.29.21
FOR MODELS NEFL72/100FH-EU ONLY: