General Information; General Instructions; Unpacking And Testing Appliance - Napoleon Allure Serie Installations- Und Betriebshandbuch

general information

EN
1.3

general instructions

• Prior to plugging your appliance into an electrical outlet, verify that the house circuit breakers for the outlet
are on.
• The appliance may emit a slight, harmless odour when fi rst used. This odour is normal and it is caused by
the initial heating of internal appliance elements and will not occur again.
• If your appliance does not emit heat when called for, consult the "operation" section of this manual for further
information.
• Use with a CSA or UL certifi ed surge protector.
CE- or GS-certifi ed surge protector.
• Do not route the power cord directly underneath the appliance.
This electric appliance meets the construction and safety standards of H.U.D. for application in manufactured
homes when installed according to these instructions.
As with most electronic devices, your new electric appliance has been designed to operate at
temperatures between 5°C (41°F) and 35° C (95°F). During the colder winter months, allow the
appliance to reach room temperature before turning it on.
1.4

unpacking and testing appliance

Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the appliance
operates properly by plugging the power supply cord into a conveniently located 220-240 volt, minimum 10 amp
grounded outlet.
note:
The NEFL72/100FH-EU appliances are shipped with the front glass not assembled onto the appliance (see
"front glass installation" section for assembly).
6
W415-1699 / F / 10.29.21