Battery Change - ZAMEL exta free RNK-02 Montageanleitung

OPERATION, MOUNTING RNK-02
All manuals and user guides at all-guides.com
By pressing the button, the transmitter sends a signal with 868 MHz frequency which
controls EXTA FREE receivers. Device programming procedure (adding a trans-
mitter to a receiver's memory) is described in particular EXTA FREE manual
instructions. The device range (up to 300 m depending on a receiver) can be
increased by means of a retransmitter or few RTN-01 retransmitters.
The device can be mounted in any place by means of double-sided adhesive tape or
wall plugs 5 x (3 x 30) mm.
Mounting by means of wall plugs:
1. Remove the button - to do it press the button on one side, and on the other side put
a screwdriver into a slot and lift up the button (Fig. 1)
2. Find a place on the wall to mount the transmitter, make two holes corresponding
mounting holes from the transmitter's base.
3. Set wall plugs in the holes.
4. Fix the base by means of screwing screws into wall plugs.
5. Place the button again.

BATTERY CHANGE

Battery discharge status is signalled by several LED red diode flashes during
transmission time.
1. Remove the button (Fig. 1).
2. By means of a screwdriver lever up the printedcircuit board releasing the bottom
latch (Fig. 2), and remove it from the base.
3. Remove the battery from the latch (Fig. 3).
4. Mount a new battery. Watch battery polarisation marked on the latch. Wrong battery
mounting may cause device damage.
5. Put the removed printed-circuit board back in the base.
6. Put the button back.
CAUTION: While changing the battery, it is suggested to press any of the but-
tons for about 5 seconds before putting it into a latch. Next press transmission
button several times to check its operation. If the transmitter does not work
properly repeat the battery change procedure.
1
CAUTION! SUBSTITUTING THE BATTERY WITH ANY BATTERY OF INCORRECT TYPE
MAY CAUSE AN EXPLOSIVE HAZARD. DISPOSE OF USED BATTERIES AS STATED IN THE
2
MANUAL.
3