Technical Characteristics - hager XEV1R22T2TE Installationsanleitung

13. Technical characteristics

Environmental conditions
Usage temperature
Storage temperature
Relative humidity
Protection
Maximum altitude of operation
Degree of pollution
Surge voltage
Electrical characteristics
Voltage
Nominal insulation voltage Ui
Usage frequency
Charging station electrical protection
Maximum charging current/power Mode 3 T2/T2S socket
(depending on version)
Maximum charging current/power Mode 2 TE-TF socket
(depending on version)
Electrical protection rating
Overvoltage category
Earth connection diagram
Minimum/possible wiring
Differential protection compatibility
Mechanical characteristics
Weight
Height
Width
Depth
Packaging characteristics
Weight
Height
Width
Depth
Classification
Power supply input
Power supply output
Environmental and usage conditions
Location of
Type of mounting
Category equipment
Charging mode
Method of electrical connection
Adaptor
Length of cable and cable extension
External ventilation
44
-25°C to +50°C
-35°C to +70°C
5% to 95%
IP 55 – IK 10
2000 m
3
4 kV
230 V~ / 400 V~ (three-phase version) -15% / +10%
250 V~ / 500 V~
50/60 Hz +/- 1%
40 A circuit breaker, C curve, energy limitation class I²t 3, on a circuit
that cannot supply more than 6 kA in short-circuit (or equivalent)
32 A - 7 kW (single-phase version) / 32 A - 22 kW (three-phase version)
16 A - 4 kW (single-phase version) / 16 A - 11 kW (three-phase version)
10 A - 2300 W
Class 1 (earth connection)
3
TN, TT
10 mm² in single or multi strand/16 mm² in multi strand.
Only the use of a copper conductor is authorised.
Type A (the 6 mA DC detection is integrated into the charging station,
according to standard NF EN 61851-1)
6 kg
549 mm
251 mm
173 mm
7.9 kg
595 mm
270 mm
300 mm
Electric Vehicle (EV) power system connected to the AC power supply
network (permanently connected)
alternating current power system for EV
indoor and outdoor use
equipment for unrestricted access areas
surface mounting on a wall, posts or equivalent positions and mounting
on a on post, column and pipe.
Installation in a horizontal position on the ceiling or on the floor is
prohibited
1
mode 3 via T2/T2S socket and mode 2 via TE-TF socket (depending on
version)
connected to plug and cable or permanently connected.
no plug adapter can be used between the charging station
and the charging cable or between the charging cable and the car
charging cable extension is not permitted; the charging cable must be in
one piece and a maximum length of 10 m
not supported