Assembly; Checking The Items Supplied; Packaging; Tightening Torques For Screws Used - actiforce ALUFORCE PRO 251 M Betriebs- Und Montageanleitung

3 Assembly

Before attempting assembly, read the safety information in Section 2.

3.1 Checking the items supplied

Carefully open the cardboard packaging.

In doing so, do not use any long knife blades. They may damage the components in-

side.
Check the parts supplied against the list in Section 1.4 Items supplied.

Do not attempt to assemble the workstation frame if there is any damage or if there are

any incorrect components.

3.2 Packaging

Remove the packaging. Treat as household waste/paper.

Observe national legislation.


3.3 Tightening torques for screws used

Assemble the workstation frame with the tools supplied only.


3.4 Assembly of the workstation

3.4.1 Pre-assembly of the Crossbar

Assemble the following components:
# Part name
13 Straight bottom crossbar
14 90 degree bottom crossbar
15 Straight top crossbar
16 90 degree top crossbar
08 Allen key M3
12.3 Set screw M6x6
Indicative:
Frame set-up Width/size tabletop
1,1 m 120 cm
1,3 m 140 cm
1,5 m 160 cm
1,7 m 180 cm
Twist the set screws in the threaded holes.


Do not yet tighten the set screws!
Tighten the set screws only after assembling the components in step 3.4.9 Adjustment

of the frame width, page 19.
Qty
1
1
1
1
1
12
9