actiforce ALUFORCE PRO 251 M Betriebs- Und Montageanleitung Seite 16

3.4.6 Mounting the Drive Shafts Leg 1 & Leg 3
Assemble the following components:
# Part name
06 Hexagon shaft Short + Long
07 Axle Drive Short + Long
19 Drive Unit Master
20 Drive Unit Slave

Be aware that both legs are completely in the lowest position.

Be aware that the drive units have not been connected to a power source and not been used.

Be aware that all components are originally packed.

Be aware that the 2 drive units are different (Master & Slave). Place the master drive unit at
the side where the up-down switch will be placed.

19
Photo 19
Slide the 2 drive shafts through the hexagon holes in leg 1 and leg 3.

Slide both shafts in until they stick ±15 cm inside the frame.

Photo 20
Slide the Master drive unit over the, to the inside of the frame sticking, drive shaft. At the

side where the up-down switch needs to be placed.
Slide the Slave drive unit over the, to the inside of the frame sticking, drive shaft. At the

opposite side of the Master drive unit (photo 21).

21
Qty
2+ 2
1+ 1
1
1
Leg 3

20
Leg 2
Leg 1
16