Mounting The Drive Units - actiforce ALUFORCE PRO 251 M Betriebs- Und Montageanleitung

3.4.8 Mounting the Drive Units

Assemble the following components:
# Part name
08 Spanner M8 & M10
12.11 Bolt M6x80
12.8 Washer M6
12.6 Flange nut M6
12.12 Spacer

23

25
Photo 23
Slide the long bolt (M6x80mm) with a washer through the specific hole in the drive unit.

Slide the plastic spacer over the already placed bolt (between the drive unit and the top support).

Photo 24
Screw a flange nut, as showed on the photo, over the bolt.

Photo 25
Slide the bolt through the specific hole in the top support.

Screw a flange nut, as showed on the photo, from the inside of the top support over the bolt.

Tighten this flange nut.

Photo 26

Be aware of that the drive unit is parallel in relation to the top support.
Repeat these steps for the other Drive Unit.
Qty
1
2
2
4
2

24

26
18