DESCRIPTION OF THE APPLIANCE AND ACCESSORIES
Look at Figure [A] in the illustration section to check the content of the packaging. All figures
are found in the inside pages.
1.
Squeezer lever
2.
Lid
3.
Cone
4.
Filter
•
Unpack the appliance.
•
Wash the removable components: the cone (3), the filter (4) and the container (5) by
hand or in the dishwasher.
•
In the dishwasher, make sure the maximum temperature of the water does not exceed
55°C.
ATTENTION!
•
The maximum time it is to be used is 5 minutes, alternating 15 seconds ON
and 15 seconds OFF. Let the appliance cool down for 5 minutes after being
used.
•
DO NOT press the squeezer lever too much as the lid (2) could break.
•
Insert the container (5) into the motor casing [Fig. B].
•
Insert the filter (4) into the container (5) [Fig. C].
•
Insert the cone (3) on the pin [Fig. D].
•
Place a jug under the dispensing nozzle (6).
•
Lower the dispensing nozzle (6).
Proceed as follows after having assembled the appliance:
•
Insert the plug in the socket.
•
Place half the citrus fruit on the cone (3).
•
Lower the squeezer lever (1) on the fruit and the appliance will start automatically.
Clean the appliance after having used it.
Remove the plug from the socket.
•
Wash the removable components: the cone (3), the filter (4) and the container (5) by
hand or in the dishwasher.
•
In the dishwasher, make sure the maximum temperature of the water does not exceed
55°C.
•
Clean the motor casing (7), the squeezer lever (1) and the lid (2) with a damp and well-
wrung sponge.
CLEANING BEFORE FIRST USE
ASSEMBLY
CLEANING AND MAINTENANCE
5.
Container
6.
Dispensing nozzle
7.
Motor casing
USE
GB
7