Can I Activate An Auxiliary Device When Viewing A Particular Camera; Instead Of Releasing The Door Via A Panel; How Can I Update The Interface Firmware; How Does The Duox Plus Auto Switch-On Work With The Interface Installed - Fermax DUOX PLUS Installationshandbuch

5.9 Can I activate an auxiliary device when viewing a particular camera,

instead of releasing the door via a panel?

Yes, it is possible by means of the advanced relay (ref. 3267), as this can be programmed
with the panel and block number of your choice. The steps would be to configure one of
the panels as a General Entrance or block and indicate the corresponding panel number
and then programme the relay with that address, then leave the panel as it should be and
so the monitors that automatically switch on that block will activate the relay.

5.10 How can I update the Interface firmware?

To update the firmware of the Duox Plus IP camera interface through the web server it is
necessary to upload the update file with the following name and extension:
Note: it is important not to change the file name.

5.11 How does the DUOX PLUS auto switch-on work with the Interface installed?

Close-up of auto switch-on operation
1 Panel 0 or Camera 0 of the Monitor block
10
DUOX PLUS IP CAMERA INTERFACE
4th Open a browser.
• 1. Go to the IP of the default interface:
• 2. Enter/create password.
The white WiFi LED will stay on continuously when
connecting to the PC.
firmwareUpgrade.tar.bz2
192.168.1.100.
Panel or Camera
Identifier