Fermax DUOX PLUS Installationshandbuch Seite 17

specified. This information depends on the individual camera, so please refer to the
manual of the camera itself.
(Press camera button
for auto switch-on from
monitor)
6.3. Enter the name of the camera for identification
(this name will only appear within the Interface).
6.4. To activate a DUOX door or relay, select the
type and number of the outdoor panel / relay of
which the door opener / contact will be activated by
pressing the door lock release button while viewing
that camera.
• Indicate the type of DUOX panel/relay in 'Door
to open'.
• Indicate the panel/relay number in 'Panel to
open'.
*If the "DUOX Configuration" facility of the Interface
is used to indicate that it is General Entry, it will only
be able to open General Entry panels, never block
panels.
6.5. When finished, save the configuration and
close.
6.6. Deactivate the web server by pressing the PRG
button for 2 seconds so that the white WiFi LED
turns off completely.
6.7. Connect the IP camera or switch where the IP
camera is located.
6.8. Verify correct operation by performing an auto
switch-on from any monitor connected to the bus
by pressing the camera icon as many times as
necessary until the desired camera is selected.
DUOX PLUS IP CAMERA INTERFACE
7