Technical Data - Meec tools 015279 Bedienungsanleitung

• Protect electrical connections from
moisture.
• Do not expose the product to
temperatures below 0°C. Make sure that
the product is not run without water.
• Do not pump aggressive liquids or
abrasive material.
• Do not pull the power cord or float switch
cord to move the product, and do not use
them to secure the product from moving.
• The product is only intended for
household use and is not suitable for
commercial purposes.
• The manufacturer cannot accept liability
for personal injury or material damage
resulting from improper use.
IMPORTANT:
The product must be connected to the mains
with a residual current device of max 30 mA.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.

TECHNICAL DATA

Rated voltage
Nominal input power
Pump pressure
Flow
Lifting height
Submersion depth
Minimum water level for
manual start
Minimum water level for
automatic start
Residual level, manual
Residual level, automatic
Particle size
Water temperature
Protection rating
Cord length
Connection
Overheating protection
Size
Weight
DESCRIPTION
An invaluable accessory when flooding is a
fact. This submersible pump from Meec Tools
is adapted for clean to moderately dirty water,
and has an impressive residual level of 1 mm.
This means it is ideal to use when the house,
for example the basement, has been exposed
to flooding. The pump also has automatic
start/stop, but can be run manually, with a
motor made of aluminium and an impressive
pump capacity of up to 133 litres per minute
(8000 l/h).
USE
CONNECTION OF OUTLET TUBE
1. Screw the outlet tube on the outlet
connection. All the connections should be
sealed with jointing tape.
230 V ~ 50 Hz
400 W
0.7 bar
133 l/min
max 7 m
max 7 m
5 mm
50 mm
1 mm
40 mm
max 5 mm
max 35°C
IPX8
10 m
1"(R25)/1 1/2"(R40)
Yes
L16,5 x W16 x H29 cm
4.6 Kg
EN
21