Trouble Shooting Chart - Meec tools 015279 Bedienungsanleitung

MAINTENANCE
CLEANING
Clean the outside of the product. Rinse with
clean water. Remove stubborn stains with a
brush and detergent. Lower the product into a
container with clean water and run for a short
time to flush the inside of the product.
NOTE:
Clean the product after it has not been used
for some time to prevent any deposits or
contaminants causing a blockage.
STORAGE
If there is a risk of frost, dismantle and clean
the product and its accessories and store in a
frost-free place.
NOTE:
Risk of material damage. The product and its
accessories contain water, which means that
they can burst if the water freezes.
TROUBLESHOOTING CHART
Problem
The product will not
start.
No flow of water.
The product does not
stop.
Too little water flow.
The product starts, but
soon stops.
Possible cause
No power supply.
The float switch has not tripped. Lift up the float switch.
The inlet is blocked.
The outlet hose is clinched.
The float switch cannot sink far
enough.
The inlet is blocked.
Parts are worn as a result of
contaminants.
Contaminants in the water
can cause the overheating
protection to trip and stop the
motor.
Hot water can cause the
overheating protection to trip
and stop the motor.
Proposed action
Check the power supply.
Clear the inlet.
Adjust the hose.
Place the product correctly on a level
surface on the bottom of the well.
Clear the inlet.
Clean the pump and replace worn
parts.
Disconnect the power supply and
clean the pump.
Make sure that the temperature of
the pumped water is no more than
35°C.
EN
23