Maintenance; Maintenance Schedule - Husqvarna GX 560 Bedienungsanweisung

Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
Before you do maintenance work
WARNING:
damage to the product, obey these

Maintenance

Do a general inspection
Examine the oil level
Clean the product
Examine the cutting equipment
Examine the cutting cover*
Examine the engine brake handle*
Examine the air filter
Examine the muffler*
Examine the spark plug
Clean the air filter
Change the air filter
Examine the fuel system
To do a general inspection
• Make sure that all nuts and screws on the product
are tightened correctly.
To clean the product
WARNING:
Before you do maintenance work on page
10 before you clean below the product.
CAUTION:
gasoline or solvents to clean the product.
That can cause damage to plastic parts.
10
Maintenance
Before you do
To prevent injury and
Obey the instructions in
Do not use detergent,
instructions when it is necessary to put the
product on its side.
1. Close the fuel valve. (Fig. 24)
2. Let the engine run until it stops.
3. Disconnect the spark plug cable. (Fig. 25)
4. Tilt the product to its left side, with the air filter (A) up
and the muffler down. (Fig. 26)

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety devices on the product on page 7 .
Daily
X
X
X
X
X
X
X
• Do not use a high pressure washer to clean the
product.
• If you use water to clean the product, do not flush
water directly on the engine.
• Use a brush to remove leaves, grass and dirt.
• Make sure that the cold air intakes are not blocked.
• Remove the fan (see
on page 11 ) and clean it with a brush.
• Clean the surface of the product with a dry cloth.
• Clean below the product with a scraper to remove
the buildup of grass and waste.
Weekly Monthly
X
X
To replace the blade and fan
461 - 010 - 27.10.2022
X
X
X