Getting Started - Hama RC 650 Bedienungsanleitung

Warning – Batteries
• When inserting batteries, note the
correct polarity (+ and - markings)
and insert the batteries accordingly.
Failure to do so could result in the
batteries leaking or exploding.
• Only use batteries (or rechargeable
batteries) that match the speci ed
type.
• Before you insert the batteries,
clean the battery contacts and the
polar contacts.
• Do not allow children to change
batteries without supervision.
• Do not mix old and new batteries
or batteries of a different type
or make.
• Remove the batteries from products
that are not being used for an
extended period (unless these are
being kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a re.
• Keep batteries out of the reach
of children.
• Never open, damage or swallow
batteries or allow them to enter
the environment. They can contain
toxic, environmentally harmful
heavy metals.
• Immediately remove and dispose of
dead batteries from the product.
• Avoid storing, charging or using the
device in extreme temperatures and
extremely low atmospheric pressure
(for example, at high altitudes).

4. Getting Started

Open the battery compartment cover
(12), remove the contact breaker and
then close the battery compartment
cover again.
5. Operation
5.1 Automatic time setting using the
DCF signal
• Once you have removed the contact
breaker, an acoustic signal sounds and
the alarm clock automatically starts
searching for a DCF signal. During the
search, the radio icon (2) will ash.
• After 5-10 minutes (depending on how
quickly the radio signal is received),
the clock sets itself to the correct time.
• When the wireless signal is received,
the date, time, weekday and
temperature are automatically set and
the radio icon (2) is displayed.
• If the clock is unable to receive a time
signal wirelessly, the time/weekday/
temperature are displayed and the
radio icon (2) is not visible. In this
case, you can set the time manually.
3