IKEA UDDARP Bedienungsanleitung Seite 6

ENGLISH
INSTALLATION
The appliance must be handled and
installed by two or more persons - risk of
injury. Use protective gloves to unpack and
install - risk of cuts.
Move the appliance without lifting it by
the worktop or top lid.
Installation, including water supply (if
any), electrical connections and repairs
must be carried out by a qualified
technician. Do not repair or replace any
part of the appliance unless specifically
stated in the user manual. Keep children
away from the installation site.
After unpacking the appliance, make sure
that it has not been damaged during
transport. In the event of problems,
contact the dealer or your nearest After-
sales Service. Once installed, packaging
waste (plastic, styrofoam parts etc.) must
be stored out of reach of children - risk
of suffocation. The appliance must be
disconnected from the power supply
before any installation operation - risk of
electric shock. During installation, make
sure the appliance does not damage the
power cable - risk of fire or electric shock.
Only activate the appliance when the
installation has been completed.
Do not install your appliance where it
may be exposed to extreme conditions,
such as: poor ventilation, temperatures
below 5°C or above 35°C.
When installing the appliance make
sure that the four feet are stable and
resting on the floor, adjusting them as
required, and check that the appliance is
perfectly levelled using a spirit level.
If the appliance is being installed on
wood or "floating" floors (certain parquet
and laminate materials), secure a 60 x 60 x
3 cm (at least) sheet of plywood to the floor
then place the appliance on top of this.
Connect the water inlet hose(s) to
the water supply in accordance with the
regulations of your local water company.
For cold fill only models: do not connect
to the hot water supply.
For models with hot fill: the hot water
inlet temperature must not exceed 60°C.
The washing machine is fitted with
transport bolts to prevent any possible
damage to the interior during transport.
Before using the machine, it is imperative
that the transport bolts are removed.
After their removal, cover the openings
with the 4 enclosed plastic caps.
After installation of the device, wait
a few hours before starting it so that it
acclimates to the environmental conditions
of the room.
Make sure that the ventilation openings
in the base of your washing machine
(if available on your model) are not
obstructed by a carpet or other material.
Use only new hoses to connect the
appliance to the water supply. The old
hose-sets should not be reused.
The supply water pressure must be in
the 0.1-1 MPa range.
If the appliance is installed near to a
gas or coal stove, provide a heat insulating
plate (85 x 57cm) in between, as the side
facing the stove is covered with aluminum
foil.
The appliance must not be installed
behind a lockable door, a sliding door or
a door with a hinge on the opposite side
to that of the appliance, in such a way
that a full opening of the machine door is
restricted
Do not repair or replace any part of the
appliance unless specifically stated in the
user manual. Use only authorized After-
sales Service.
Self or non-professional repair may lead
to dangerous incident resulting in live
or health threatening and/or significant
property damage.
Spare parts will be available for a period of
either up to 7 or up to 10 years, according
to the specific regulation requirements.
The spare parts can be found:
https://parts-selfservice.whirlpool.com/en/
landing
6