Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly
Important! The fitting must be installed, flushed
and tested after the valid norms.
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink.
3. Slip the plastic washer, the slide washer, the
metall washer and collar nut over the hose and
threaded base and tighten the collar nut by hand.
If there is not enough space, please use only the
slide washer and the metall with-out the plastic
washer.
4. Tighten screws.
5. Connect the connecting hose to the angle valves;
cold right - hot left.
The hot and cold supplies must be of equal pres-
sures.
Technical Data
This mixer series-produced with water-
dimmer
(flow limiter)
®
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 12 l/min 0.3 MPa
Operating pressure:
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temperature: 65° C
Hansgrohe mixers can be used together with hydrau-
lically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer (4a)
located behind the mousseur must be removed.
English
11 l/min 0.3 MPa
max. 1 MPa
1,6 MPa
max. 80° C
Spare parts (see page 3)
1
handle
2
screw cover, cold/ hot
3
spout large model
4
aerator cpl.
5
shut off unit
6
fixation set
7
connection hose 900 mm
8
sleeve
9
fixation extension
XXX = Colors
000 chrome plated
820 brushed nickel
830 polished nickel
16291XXX
97987000
98616XXX
98617XXX
94009000
13961000
97202000
97993XXX
13898000
Werbung
