Warning Reference - Dräger Polytron 8100 Gebrauchsanweisung

Maintenance
6.3.2

Warning reference

Warning
Cause
number
#101 Data-logger in Stack mode is 100 % full and
is not logging any more data.
#102 Data-logger in Stack mode is 90 % full.
#103 Data error in the instrument. Some functions
#106 like data-logger, sensor test, etc. may no
longer be available.
#104 Date or time setting not valid.
#107 Battery for data memory empty.
#110 SW dongle has been removed without being
#111 deactivated.
#112
#113 Alarms inhibited.
#164 Sensor warm-up phase has not ended.
#165 Increased measurement error must be
expected.
#167 Calibration interval expired.
#170
#171 Negative reading. Value below range
minimum.
34
Remedy
Download the data, clear the data-logger.
Download the data as soon as possible and clear the data-
logger.
Reset the instrument to factory default settings (see Section 7
on Page 36).
If this error occurs again:
Have the instrument checked by DrägerService.
Set date and time (see Section 5.8.3 on Page 22).
Have the instrument checked by DrägerService.
Deactivate SW dongle (see Section 5.11 on Page 29).
Enable alarms (see Section 5.8.1 on Page 21).
Wait until the sensor has warmed up. Do not calibrate before
sensor is fully warmed-up.
Recalibrate the instrument (see Section 6.2 on Page 30).
Recalibrate zero point.
Dräger Polytron 8100