I Ncorrect Use - SUHNER ABRASIVE WH 13 Originalbetriebsanleitung

1. N
1.1 g
enerAl nOtes On sAfety
This operation manual is applicable for the hand tool WH
13.
The hand tool may only be handled by personnel
who are qualified.
It is imperative that you observe the safety instruc-
tions provided separately for the drive.
1.2 u
se Of the mAchine fOr purpOses fOr
which it is intended
The hand tool is designed for dry processing on metal
surfaces, for polishing and satin finishing with tool diam-
eters which are max. 175 mm.
1.3 i
ncOrrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 d
eclArAtiOn Of incOrpOrAtiOn
The manufacturer Suhner Schweiz AG of Industriestrasse
10, CH-5242 Lupfig, hereby declares for the partly com-
pleted machinery (see reverse side for type and serial no.)
that the following fundamental requirements of the Direc-
tive 2006/42/EC are applied and fulfilled in accordance
with Annex I: 1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.3.7, 1.3.8.1,
1.5.1, 1.5.4, and 1.6.1. Technical documentation was gen-
erated for the partly completed machinery in accordance
with Annex VII of the Machinery Directive. Document
Agent: T. Fischer. Authorised sites are provided with this
technical documentation in paper or electronic form on
justified request. This partly completed machinery may
be put into operation only when the machine in which the
partly completed machinery is to be incorporated has
been ascertained to fulfil the conditions under the Ma-
chinery Directive. CH-Lupfig, 09/2020. T. Fischer/Division
manager
2. C
2.1 A
ssemBly instructiOns
hand tools.
Use only hand tools, shafts, and grinding tools in perfect
condition.
Attach the hand tool to the shaft only when the drive is
switched off and has come to a stop.
Connect grinding tools only when the drive is switched off
and has come to a stop.
16
S
oTES oN aFETy
ommISSIoNINg
It is imperative that you
read Sections 2 and 3 be-
fore you start operating the
It is imperative that you use the guards intended for the
hand tool.
Observe the specifications applying to your country.
2.1.1 A /
ttAching detAching the hAnd tOOl
Remove locking screw (1). Press the locking button and
insert the hose coupling into the hand tool hole (2). Make
sure that the locking button is engaged. Follow these in-
structions in reverse order to detach the hand tool.
2.1.2 A /
ttAching detAching the sAfety guArd
Turn the safety guard to the position you want. The screw
must be tightened to secure the safety guard in place.
Follow these instructions in reverse order to detach the
safety guard.
2.1.3 A /
ttAching detAching the grinding tOOl
Loosen the nut and remove it with the pressure disc (1).
Fit the tool (2), refit the pressure disc, lock the spindle with
the spanner (3), tighten the nut (1). Disassembly must be