auna TC7-MVD-180 Bedienungsanleitung Seite 33

BLUETOOTH OPERATION (BT)
1. "Pair" To Your BT Phone
Prior to using the Car Kit for the fist time, you
must pair it with a BT-enabled mobile handset.
The following steps describes pairing the
instruction for a typical BT- enabled mobile
handset.
1) Place the Car Kit and mobile hand- set
in 3 meters apart.
2) Put the Car Kit in pairing mode.
a. Press the POWER button to turn
ON, the BT ICON will flash on TFT.
b. Touch the screen of "
until the word "BT" icon flashing.
3) Set your BT phone to "discover" the
Car Kit. Following your phone's
instruction guide for details.
4) Your phone will find this Car Kit.
Select this Car Kit from the list.
5) Enter passkey "8888".
6) Select the "CONNECT " from the list
on the phone, , the BT ICON remains
solid on the screen.
IMPORTANT:
1) If the pairing can not be completed
within approximately 2 minutes.
Otherwise see steps 2-5 above.
2) After pairing is completed, if the BT
ICON is stilling flash on the TFT,
please follow this steps.
2. Using The BT Car Kit
Once connecting is complete, you may access
the following function..
MAKE A CALL
Touch the screen of "
numbers will display on the monitor. Then you
can touch the number section on screen , and
then touch the "
Note: When you dial the wrong number, you
can touch the screen of "" to delete the
wrong number.
" section
" section, the dial
" section to call
Please note: "*" and "#" serves as the "*" and
"#" button on your mobile handset.
ANSWER A CALL
After you hear the ring tone, a incoming
telephone number will display on the TFT
monitor. Touch the screen of "
listen or press the "PAIR" button shortly on the
remote control.
CALL TRANSFER
During talking mode, user can touch the
screen of the " " range or press "PAIR"
button on remote control to transfer the audio
from the unit back to the mobile phone.
END/REJECT A CALL
In BT menu, touch the screen of "
or REDIAL on remote control.
REDIAL LAST NUMBER
In BT menu, touch "
longer " REDIAL" button on the remote
control the "DIAL LAST CALL/DIAL OUT NOW"
will display on the TFT monitor.
ADJUST THE VOLUME
During conversation in progress, tune the
Volume switch until you reach the desired
volume level.
BT Music
In BT mode, repeatedly the MOD on the panel
to select the "BT MUSIC" Mode. The message
will display like following as follows:
Note:
the function of resume playback after pausing
or stopping is available only for some mobile
phone.
Note:
1) Please check your phone's instruction
guide or contact phone manufacture.
2) You need make your call-phone and the
unit successfully for one time. Afterwards
the function of BT will work in three
minutes automatically if you want to
operate the function of BT .
3) If you want not to use the function of the
BT about the unit, you can select BT OFF.
" range to
" range
" range (or press