CeraGem MASTER V4 Gebrauchsanweisung Seite 13

3. How to use the remote control
Setting the strength
1. Check the current strength and press the strength
button.
- The current strength of the internal projector will be displayed
on the main screen.
- When the product is closed, the closed product image will be displayed.
2. Set the strength as desired by pressing the strength
button or the up/down button while the relevant item
is displayed in yellow.
- Set the desired strength by using the strength button or the up/down button
while the relevant item is displayed in yellow.
- Strength can be set at Levels 1 ~ 9.
3. Check the changed strength setting on the screen of
the remote control.
22
3. How to use the remote control
Setting the thermal sofa mode (supporting mat closed)
1. Turn on the remote control and check the screen.
- The abdominal vibration projector and 3-sphere projector will only
be displayed when connected and the position may vary according
to the installation order.
2. Select a desired item by pressing the temperature
select button, and set the desired temperature by
pressing the up/down button.
- When a temperature is selected, the image of the relevant item will be
displayed in red.
- When the thermal sofa mode is used, the temperature of the internal
projector and the main body mat (preheating) can be adjusted.
Internal projector Main body mat
1
2
Off, 30~65℃
3. After setting the temperature, the current temperature
will be displayed.
- If the remote control is operated while using the product, the time
remaining will be initialized.
Do not use the external projectors (abdominal vibration
projector, 3-sphere projector) on any part of the body for
an extended period of time.
Caution
(There is risk of receiving a burn, even at a low temperature.)
3-sphere Abdominal
Supporting mat
projector vibration projector
Off, 30~60℃
23