Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OBJ_BUCH-39-005.book Page 21 Tuesday, June 8, 2010 1:45 PM
Connecting the Multi Sander
(see figure F)
The supplied multi sander 1 can be used in the
"Extraction" operating mode of the vacuum
cleaner 4.
The closing cover with blower filter 12
should be inserted in the holder 10. The
blower filter cleans the blown out air.
Insert the vacuum hose 3 into the vacuum hose
connection of the multi sander 22.
Ensure that a dust bag is inserted in the vacuum
cleaner when sanding.
To remove the vacuum hose 3, rotate the hose a
little and pull it off.
Replacing the Sanding Sheet
(see figure G)
When attaching a new sanding sheet, remove
any dust or debris from the sanding plate 24
(e. g. with a brush).
To ensure optimum dust extraction, pay atten-
tion that the punched holes in the sanding sheet
match with the holes in the sanding plate.
The sanding plate 24 is fitted with Velcro back-
ing for quick and easy fastening of sanding
sheets with Velcro adhesion.
Before attaching the sanding sheet 25, free the
Velcro backing of the sanding plate 24 from any
debris by tapping against it in order to enable
optimum adhesion.
The multi sander is equipped with 2 sanding
sheets. Depending on their condition of wear,
these can also be changed individually.
Use the multi sander only when both sand-
ing sheets are attached.
Only use sanding sheets with the same
grain size.
Position the sanding sheet 25 flush alongside
one edge of the sanding plate 24, then lay the
sanding sheet onto the sanding plate and press
firmly.
To remove the sanding sheet 25, grasp it at one
of the tips and pull it off from the sanding plate
24.
Bosch Power Tools
Sanding sheets of the Bosch Delta Sander can
be used.
Sanding accessories, such as fleece pads/pol-
ishing cloth pads, are attached to the sanding
plate in the same manner.
Selecting the Sanding Sheet
Depending on the material to be worked and the
required rate of material removal, different
sanding sheets are available:
For the working of all
wooden materials
For coarse-sanding, e. g.
of rough, unplaned beams
and boards
For face sanding and plan-
ing small irregularities
For finish and fine sanding
of hard woods
For the working of
paint/enamel coats or
primers and fillers
For sanding off paint
For sanding primer
For final sanding of prim-
ers before coating
For reworking or polishing, especially of metal
and stone, use fleece/polishing cloth pad.
Depending on the desired surface quality of the
workpiece, different fleece types or polishing
cloth pads are to be used.
English | 21
Grain size
40—180
coarse
40
medium 80, 120
fine
180
40—180
coarse
40
medium 80, 120
fine
180
1 609 929 V23 | (8.6.10)
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
