Bosch PSM VENTARO 1400 Originalbetriebsanleitung Seite 20

OBJ_BUCH-39-005.book Page 20 Tuesday, June 8, 2010 1:45 PM
20 | English
Vacuum cleaner
We declare under our sole responsibility that
the product described under "Technical data" is
in conformity with the following standards or
standardization documents: EN 60335 and the
directives 2006/42/EC, 2004/108/EC including
their amendments.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
30.12.2009
Assembly
Switch off the vacuum cleaner before at-
tempting to carry out any work on it or on
the sander.
Replacing/Inserting the Dust Bag
(see figures B and C)
Unlatch both latches 5 and fold up the vacuum
lid 14.
Open the closing flap 16 and guide the dust bag
18 from the top into the guide 17 as shown in
the figure. Shut the closing flap 16 again until it
can be heard to engage.
When removing a full dust bag, ensure that the
dust bag enclosure is clean. If required, clean
the enclosure with a moist cloth or a brush.
Fold down and lock the vacuum lid 14 with the
latches 5.
1 609 929 V23 | (8.6.10)
Operating Modes of the Vacuum
Cleaner (see figure A)
Before using the vacuum cleaner, always re-
move the plug cap 9. Pay attention that the
bypass valve 15 is never restricted or
blocked. The motor of the vacuum cleaner
can overheat und become damaged.
Vacuuming Function
The vacuum cleaner 4 can be used to vacuum
dry, non-hazardous materials. The supplied mul-
ti sander 1 can be used in this operating mode.
For vacuum cleaning, the dust bag must be in-
serted. For this, see chapter "Inserting/Replac-
ing a Dust Bag".
Align the arrows on the vacuum hose 3 and the
vacuum hose connection 8 and insert the vacu-
um hose into the vacuum hose connection. You
will hear a distinct "click" when the vacuum
hose locks in the vacuum hose connection.
You can connect the multi sander 1 or any of the
accessories mentioned on the accessories page
to the vacuum hose 3.
Blower Function
The vacuum cleaner 4 can easily be converted to
a blower in no time at all.
Remove the closing cover with blower filter 12
from the holder 10 and insert the adapter for
the blower connection 11 in its place.
Align the arrows of the vacuum hose 3 and the
adapter for the blower connection 11 and insert
the vacuum hose into the adapter. You will hear
a distinct "click" when the vacuum hose locks in
the adapter.
Do not point the blower jet at persons or an-
imals. The blown-out air is warm.
Removing the Vacuum Hose
To remove the vacuum hose 3, rotate the hose a
little and pull it off.
Bosch Power Tools