Getting Started; Using Checkme - Viatom Checkme Lite Benutzerhandbuch

2.

Getting Started

2.1 Power On/Off
Press the Home button to power on the device. Press and hold Home button for
2 seconds to power off thedevice.
2.2 Initial Settings
The first time when the Checkme is powered on, you can set up your Checkme step
by step. You can also change the settings in the <Settings> menu.
3.

Using Checkme

3.1 Prior to
Use Before
using ECG
Before using Daily Check or ECG Recorder function, pay attention to the following
points in order to obtain precise measurements.
If your skin or hands are dry, moisten them before taking the measurement.

During the measurement, do not touch your body with the hand with which

you are taking the measurement.
Please note that there must be no skin contact between your right and left

hand. Otherwise, the measurement cannot be taken correctly.
Stay still during the measurement, do not speak and move.

If possible, take the measurement when sitting instead of standing.

Before using Oximeter
Before using Daily Check and Oximeter function, pay attention to the following
points in order to obtain precise measurements.
The finger inserted in SpO

Any of the following conditions may cause inaccurate measurements, including

but not limited to:
CE marking
Authorized representative in the European community
UKCA marking
Authorized Representative in the United Kingdom
Non-ionizing radiation
sensor must be clean.
2
4