Specifications; Die Grinder Safety Warnings - Makita GD0801C Betriebsanleitung

ENGLISH
(Original instructions)
1 Lock-off lever
2 Switch lever
3 Speed adjusting dial
4 Side handle

SPECIFICATIONS

Max. wheel point diameter
Rated speed (n) / No load speed (n
• Due to our continuing program of research and
development, the specifications herein are subject to
change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding ferrous materials or
deburring castings.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.

DIE GRINDER SAFETY WARNINGS

Safety Warnings Common for Grinding Operation:
1. This power tool is intended to function as a
grinder. Read all safety warnings, instructions,
illustrations and specifications provided with
this power tool. Failure to follow all instructions
listed below may result in electric shock, fire and/or
serious injury.
Explanation of general view
5 Wrench 19
6 Wrench 13
7 Collet nut
8 Tighten
Model
Collet size
Max. wheel diameter
Max. mandrel (shank) length
Overall length
Net weight
Safety class
GD0801C
Max. 8 mm
) 29,000 min
0
2. Operations such as sanding, wire brushing,
polishing or cutting-off are not recommended to
be performed with this power tool. Operations for
which the power tool was not designed may create a
hazard and cause personal injury.
3. Do not
ENE050-1
specifically designed and recommended by the
tool manufacturer. Just because the accessory can
be attached to your power tool, it does not assure
safe operation.
4. The rated speed of the accessory must be at
ENF002-2
least equal to the maximum speed marked on
the power tool. Accessories running faster than
their rated speed can break and fly apart.
5. The outside diameter and the thickness of your
accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories
cannot be adequately controlled.
6. The arbour size of accessories must properly fit
GEA010-1
the collet of the power tool. Accessories that do
not match the mounting hardware of the power tool
will run out of balance, vibrate excessively and may
cause loss of control.
7. Mandrel mounted accessories must be fully
inserted into the collet or chuck. If the mandrel is
insufficiently held and/or the overhang of the wheel
is too long, the mounted accessory may become
loose and be ejected at high velocity.
8. Do not use a damaged accessory. Before each
GEB034-9
use inspect the accessory such as abrasive
wheels for chips and cracks. If power tool or
accessory is dropped, inspect for damage or
install
inspecting and installing an accessory, position
yourself and bystanders away from the plane of
the rotating accessory and run the power tool at
maximum
Damaged accessories will normally break apart
during this test time.
9 Loosen
10 8 mm (5/16") Max.
25 mm
40 mm
–1
390 mm
2.0 kg
/II
use accessories
an undamaged accessory.
no-load speed
GD0811C
Max. 8 mm
50 mm
40 mm
–1
7,000 min
390 mm
2.0 kg
which are not
After
for one minute.
3