Creality CR-5 Pro Benutzerhandbuch Seite 11

6. Level the Platform
Auto-Levelling
If you need to realize the auto-levelling, you can have a setting:
Notes: The UI information is only for reference; the actual UI may be different.
7. Preheat
Method 1
Method 2
When turning ABS to PLA, the nozzle temperature should be raised to 240°C, and
then replace with PLA. After PLA reaches the nozzle, to feed-in about 150mm to extrude
the remaining ABS, and then the nozzle temperature is reduced to 200°C and start to
print.
11