Connection Of An External Loudspeaker; Volume Adjustment; Trouble-Shooting; Warranty - Viessmann 5572 Bedienungsanleitung

Hint:
This sound module plays the sound if no figure is connected to the synchronous input.

4.1 Connection of an external loudspeaker

The sound module is equipped with an output for an external loudspeaker with electrical values of 8 ohm impedance at
least and 1/2 watt power at least (can be purchased in an electronics specialized shop). In case you connect an external
loudspeaker the integral loudspeaker will be switched off.
1. Please pull the sound module's short blue cable out of the socket right beside it.
2. Insulate the blue cable, to avoid any contact with other cables.
3. Mount the external loudspeaker at the intended place.
4. Install the two wires of the external loudspeaker to the sound module.
5. Connect the two wires to the two sockets according to fig. 3.
You can use plugs and sockets for the connection, e. g. Viessmann item 6875 (orange plug) and item 6884 (orange
socket).

4.2 Volume adjustment

The sound module is equipped with a volume control for the sound. The adjustment is valid as well for the integral loud-
speaker as for an external loudspeaker.
To adjust the volume, use a slotted screwdriver and proceed as follows (see fig. 4):
Increase volume:
-
Turn the poti to the right.
- Reduce volume:
Turn the poti to the left.

5. Trouble-shooting

All Viessmann products are produced with high quality standards and are checked before delivery. Should a fault occur
nonwithstanding, you can do a first check.
Please check first the power supply and the wiring.
No sound from the module. No sound from the external loudspeaker.
- Turn the poti to the right.
- Please make sure that the small blue plug at the housing of the sound module is removed from the socket and is in-
sulated.
Connect the external loudspeaker as shown in fig. 3.
Please refer to chapter 6 "Warranty" if you cannot find the cause of the failure and, therefore, cannot rectify it.

6. Warranty

Each model is tested as to its full functionality prior to delivery. The warranty period is 2 years starting on the date of pur-
chase. Should a fault occur during this period please contact our service department (service@viessmann-modell.com).
Please send the item to the Viessmann service department for check and repair only after consultation. If we find a ma-
terial or production fault to be the cause of the failure the item will be repaired free of charge or replaced. Expressively
excluded from any warranty claims and liability are damages of the item and consequential damages due to inappropri-
ate handling, disregarding the instructions of this manual, inappropriate use of the model, unauthorized disassembling,
construction modifications and use of force, overheating and similar.

7. Technical data

Operation voltage:
Operation current:
Insulation:
Temperature/humidity (operation):
Temperature/humidity (storage):
Weight:
Dimensions:
10 – 16 V AC ~
14 – 24 V DC =
ca. 150 mA
IP20
0 – 40° C
-10 – 60° C
ca. 50 g
L 88 x W 53 x H 22 mm
5