Model assembly
Fuselage installation
1. Pass the servo leads through the front fuselage as shown in the figure,
and insert channels CH2 and CH4 into the corresponding channels of Reflex.
NOTE:The connectors on both side should be attached precisely and firmly.
Landing gear installation
1. With the bottom of the fuselage facing up and the tires
facing forward,install the landing gear set to the fuselage.(Fit
the hook into the slot as shown.)
2. Secure the landing gear with the included screws and tabs.
2. Use the attached screws to fix the front
and rear fuselage.
HKM3.0*10
4
HKM3.0*10
E
N