Nolan N60 6 Sicherheit Und Gebrauchsanleitung Seite 18

N60-6
1.3 Remove the rear tab of the comfort padding of the left cheek pad from the cavity
between the rear trim and the polystyrene inner shell; then completely remove the
cheek padding from the helmet (Fig.10).
1.4 Follow the same steps on the right side of the helmet.
Do not remove the polystyrene cheek pads from the helmet shell.
2 DISASSEMBLING THE INNER EXPANDING FOAM PADDING OF THE CHEEK PADS
To facilitate the washing of the inner comfort padding components, the cheek pads of
the helmet are fitted with inner expanding foam padding that can be removed from the
fabric lining. To remove the padding, proceed as follows after disassembling the cheek
pads from the helmet (see instructions above).
2.1 Unhook the three eyelets "A" of the rear frame of the left cheek pad at to the three
snap buttons (top, front, and rear) on its back (Fig.11).
2.2 Take the top "B" and bottom "C" tabs of the frame out of the respective loops on
the back of the frame (Fig.11).
2.3 Gently remove the inner expanding foam padding from the fabric lining of the
cheek pad (Fig.12).
2.4 Repeat these steps with the padding of the right cheek pad.
Warning: once the inner expanding foam paddings have been removed from the
cheek pads, ensure that the front, rear, and top snap buttons (shaped differently
from the others) are correctly hooked to the rear frame of the fabric lining of the
cheek pads. Otherwise, reposition them appropriately.
3 DISASSEMBLING THE LINER
3.1 Release the left rear tab of the liner from the shell rear edge by slightly pulling the
comfort padding inwardly (Fig.13). Then repeat the operation also for the right rear
tab.
3.2 Hold the left front part of the liner and pull it upwards in order to remove the cor-
responding liner tab from the support fixed to the polystyrene inner shell (Fig.14).
Then repeat the steps with central front and right tabs as well.
3.3 Completely remove the liner from the helmet.
4 ASSEMBLING THE LINER
4.1 Insert the liner correctly into the helmet and have it well fitted against the base.
4.2 Insert the left front tab of the liner into the corresponding seat on the support fixed
to the polystyrene inner shell and push it downwards until it is completely hooked.
Repeat the operation with the central and the right tabs too (Fig.14).
Warning: Check the correct assembly of the liner front area by lifting and lowering
the VPS. These movements should be smooth. If this is not the case, repeat the
steps 3.2 and 4.2.
4.3 Insert the rear right and left tabs of the liner into the corresponding seats of the
shell edge (Fig.13). Push the tabs until they are fully hooked onto the support.
18
INSTRUCTIONS FOR USE