Basic Settings; Selecting Titles And Folders - Omnitronic DMP-103RDS Bedienungsanleitung

Indicating RDS information
If the station selected broadcasts RDS data (radio data system), the button RDS lights up. Press the button
to indicate the information (PS, DATE, PTY and TEXT) in the display.
CD player operation
Loading/ejecting a CD
1) Slide in a CD with the lettering upwards so far into the slot until it is retracted automatically. The display
indicates LOAD.
2) To eject the CD press the button EJECT [ ]. The display will indicate EJECT and the CD will be
ejected and can be removed. Before ejecting the CD always pause the playback with the button
While playing a CD, the CD drive is locked against unintentional opening.
Loading/removing USB devices
1) Insert USB devices into the USB port. To switch from the CD to a USB device, set the unit to pause with
the button [ II] and press the selector switch CD/USB. In USB mode, the LED next to the USB port
lights up.
2) To remove a USB device, disconnect it from the USB port. Before removing the USB device always
pause the playback with the button [ II]. Otherwise damage or loss of data may occur.
Regarding data carriers
• This unit supports MSC (Mass Storage Class) USB storage devices 1.0, 1.1, 2.0 including external portable
flash memory devices and digital audio players. However, hard discs, optical discs such as external CD/DVD
drives will not be recognized. Depending on the device used, proper playback may not be possible with all
USB storage devices.
• When connecting a data carrier with a large number of folders and files, some time may be required to read
in the contents.

Basic settings

After switching on, the modes continuous play and elapsed title time will be active as basic settings. These
settings can be changed.
1) In the basic setting continuous play all titles of are played one after the other and the unit stops at the
end of the last title. Press the button SINGLE (LED lights red) on the player or the button SGL/CTN on
the remote control to switch to single title play. Then the unit is set to pause at the start of the next title
after playing a title.
2) As a basic setting, the display will show the elapsed time of the current title numerically in minutes,
seconds and frames (1 frame = 1/75 second). With the button TIME the time indication can be switched
over:
• first actuation of the button: remaining title time
• second actuation of the button: total remaining time (only with audio CDs)
• third actuation of the button: return to basic setting
In addition to numerical time indication, the playing time is indicated graphically by the length of the
bargraph for audio CDs. The number of segments of the bargraph will be increased with increased
playing time. The bargraph will begin to flash in its full length 30 seconds before the playing time is
ending.

Selecting titles and folders

1) With the buttons [ ] and [ ] you can skip one title or several titles in forward or backward direction.
Each time the button [ ] is pressed, the unit will advance one title. By pressing the button [ ], the unit
will go to the beginning of the title and with each further actuation, the unit will go back another title. The
title number is indicated in the display. Additionally, the artist and title name will be displayed as
scrolling text information in the text line for MP3 files.
2) With MP3 CDs folders can be selected with the button PROG/FLD. Each time the button is pressed, the
unit will go to the first title of the next folder.
3) By pressing the button +10, the unit will advance 10 titles.
4) For direct selection of a title with the numerical keys 0-9 on the remote control, enter its number.
26
.