Speaker Connection - Sony XM-5ES Bedienungsanleitung

 3-channel input
With "Speaker Connection" (page 14)  or .
AUDIO
OUT
INPUT MODE
CH 1-4
+ +
1-4 1 3/2 4
-
1 1 2
* Use a speaker wire-to-RCA adaptor (not supplied) for high-
level input connection.
Note
When making this connection, set the INPUT MODE settings
on the control panel (top panel) to the following positions:
– Set CH 1-4 to "1-4".
– Set SUB CH to "5".
14
GB
SUB
* *
OUT
SUB CH
5 3+4
+
5+6 1 2

Speaker Connection

• Be sure to use speakers with an adequate power
rating. If you use small capacity speakers, they
may be damaged.
• Do not connect any active speakers (with built-in
amplifiers) to the speaker terminals of the
amplifier. Doing so may damage the active
speakers.
• Use speakers with an appropriate impedance
rating.
– 2 Ω to 8 Ω (stereo)
– 4 Ω to 8 Ω (bridged connection)
• Do not connect the  terminal of the speaker
system to the car chassis, and do not connect the
 terminal of the right speaker with that of the
left speaker.
Notes
• According to your needs, set the FILTER, RANGE, INPUT
SENS, etc. to the appropriate settings for CH 1/2 and CH 3/
4.
• The following is a depiction of the speaker connections
typically used to connect this amplifier. Refer to the
operating instructions supplied with your car audio and
speakers for more details about the speaker connection
for your car audio unit.
 4 speaker + 2 subwoofer system
With "Input Connection" (page 12) , , , ,
 or .
Front speaker (min. 4 Ω)
Rear speaker (min. 4 Ω)
Subwoofer (min. 4 Ω)