ELGA VEOLIA Purelab Chorus 2 Bedienungsanleitung Seite 7

SET - UP
1b
MODULAR STACKING, RESERVOIR UNDERNEATH (OPTIONAL)
a. Screw down the reservoir plate.
• Load bearing plate 15/30L
2
CONNECT THE WATER (PORT No. 1)
a. Remove the transit plugs from the water
inlet connection.
3
CONNECT THE DRAIN (PORT No.3)
a. Remove the transit plugs from the water
outlet connection.
Connect the other end of the drain and overfl ow tubes to a sink or suitable drain capable of handling at least 1.5 l/min.
The drain point should have a gravity fall below the level of the unit and any connections direct to drain should have
an air-break device fi tted.
b. Place on top of reservoir, line up with
bolt heads. Screw in joining bolt (FXBOYR301716).
b. Using the tube supplied, fi rmly push one end
securely into the water connector.
CAUTION!
Ensure drain pipe is not in waste water.
or
b. Using the tube supplied, fi rmly push one end
securely into the water connector.
8mm Ball Valve 2 Way
or
or