Insert The Batteries Into The Training Computer; Functions Of The Training Computer - FitEngine 06114 Bedienungsanleitung

EN
Insert the Batteries into the
Training Computer
PLEASE NOTE!
■ Use only the battery type specifi ed in
the technical data.
■ Take the batteries out of the training
computer if they are dead or if you will
not be using the device for a pro-
longed period. This will prevent any
damage caused by leaks.
■ Remove leaking batteries from the
training computer immediately.
Before inserting the batteries, check
whether the contacts in the training com-
puter (3) and on the batteries are clean,
and clean them if necessary.
The battery compartment is located on the
back of the training computer:
1. grip and press down the locking lugs
on the battery compartment cover.
Open the battery compartment cover
at the same time.
2. Insert two batteries into the battery
compartment (1.5 V; AA). Make sure
the polarity (+ / –) is correct.
3. Close the battery compartment. When
you do this, make sure that the locking
lugs sit in the recesses which are
provided for them. The battery com-
partment cover must be heard to click
into place.
If the training computer stops working, the
batteries have to be replaced.
Functions of the Training
Computer
(Fig. C)
• The training computer (3) is switched
on by pressing the ON / OFF button
for about 3 seconds.
• In the upper left area the (extrapo-
lated) number of strokes per minute
14
09605_Inlay_DE-EN-FR-ES-IT_A5_V4.indb 14 09605_Inlay_DE-EN-FR-ES-IT_A5_V4.indb 14
SPM is displayed. If the movement
stops it displays 0.
• In the upper right section the display
can show CAL, STR and SPEED in
KM/H or MI/H. Press the relevant but-
tons to switch between the displays.
• When the CAL, STR or KM/H and
MI/H displays fl ash during exercise,
all the values are shown continuously
for a few seconds.
• If one of the displays has been select-
ed via the buttons, both the unit and
the value are shown constantly on the
display.
Please Note: If a display has been
selected, the display cycle can only
be reset by resetting all the displays
(RESET).
• To change the SPEED display from
KM/H to MI/H or vice versa, press the
KM/MI button for approx. 5 seconds.
A beep sounds and all displays go off
and on again.
• In the lower left area the exercise time
(TIME) is displayed.
• In the lower right area the distance
(DIST) in km (K) is displayed.
• If the RESET key is pressed for
approx. 5 seconds, all the values are
reset to zero. A beep sounds and all
displays go off and on again.
• If there is no activity for approx. 2
minutes, the training computer will
automatically switch off .
Use with Smartphone
The training computer (3) has a wireless
connection function which is also switched
on automatically. This allows you to con-
nect your smartphone* quickly and easily
to your exercise device. You will fi nd the
training computer under the device name
"Qw-H01" on your smartphone.
* The training computer is compatible with many fi tness
apps.
14.06.2021 12:20:02 14.06.2021 12:20:02