Technical Data; Declaration Of Conformity; Auxiliary Handle - Bosch GBH 2-26 DBR Professional Originalbetriebsanleitung

vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.

Technical Data

Rotary Hammer
Article number
Speed control
Stop rotation
Right/left rotation
Rated power input
Impact rate
Impact energy per stroke
according to EPTA-
Procedure 05/2009
Speed
Tool holder
Spindle collar diameter
Drilling diameter, max.:
– Concrete
– Brickwork
(with core bit)
– Steel
– Wood
Weight according to
EPTA-Procedure 01/2003
Protection class
The values given are valid for a nominal voltage [U] of
230 V. For different voltages and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Bosch Power Tools
GBH 2-26 DBR
Professional
0 611 255 5..
W 800
-1
min 0–4000
J 2.7
-1
min 0–900
SDS-plus
mm 50
mm 26
mm 68
mm 13
mm 30
kg 2.9
/ II

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 10.09.2010
Assembly
Before any work on the machine itself, pull
the mains plug.

Auxiliary Handle

Operate your machine only with the auxilia-
ry handle 11.
Changing the position of the auxiliary handle
(see figure A)
The auxiliary handle 11 can be set to any posi-
tion for a secure and low-fatigue working pos-
ture.
– Turn the bottom part of the auxiliary handle
11 in counterclockwise direction and swivel
the auxiliary handle 11 to the desired posi-
tion. Then retighten the bottom part of the
auxiliary handle 11 by turning in clockwise di-
rection.
Pay attention that the clamping band of the
auxiliary handle is positioned in the groove
on the housing as intended for.
English | 19
Dr. Eckerhard Strötgen
Head of Product
Certification
X XXX XXX XXX | (8.9.10)