Aligning The Angle Indicator (Vertically); Aligning The Fence; Setting The Standard Bevel Angle 0° (Vertical); Setting The Standard Bevel Angle 45° (Vertical) - Bosch GTM 12 Professional Originalbetriebsanleitung

OBJ_BUCH-302-005.book Page 66 Tuesday, June 9, 2009 2:19 PM
66 | English

Aligning the Angle Indicator (Vertically)

(see figure R)
– Bring the power tool into the chop and mitre
saw working position. (see "Working Posi-
tion", page 59)
– Turn the saw table 24 to the 0° detent 29.
The lever 28 must be felt to engage in the de-
tent.
Checking:
The angle indicator 49 must be in alignment
with the 0° mark of the scale 50.
Adjusting:
– Loosen the screw 58 with the slotted screw-
driver provided and align the angle indicator
alongside the 0° mark.
– Afterwards, check to ensure that the adjust-
ment made is correct for the 45° mark.
– Retighten the screw again.

Aligning the Fence

– Bring the power tool into the table saw work-
ing position. (see "Working Position",
page 67)
– Turn the saw table 24 to the 0° detent 29.
The lever 28 must be felt to engage in the de-
tent.
Checking: (see figure
– Adjust an angle gauge to 90° and position it
between the fence 32 and the saw blade 7 on
the saw table 24.
The leg of the angle gauge must be flush with
the fence over the complete length.
Adjusting: (see figure
– Loosen all Allen screws 39 with the Allen key
provided.
– Turn the fence 32 until the angle gauge is
flush over the complete length.
– Retighten the screws again.
1 609 929 U05 | (9.6.09)
Setting the Standard Bevel Angle 0°
(Vertical)
– Bring the power tool into the table saw work-
– Turn the saw table 24 to the 0° detent 29.
Checking: (see figure
– Adjust an angle gauge to 90° and position it
The leg of the angle gauge must be flush with
the saw blade 7 over the complete length.
Adjusting: (see figure
– Loosen the nut (size 10 mm) of the Allen
– Screw the Allen screw 59 with a suitable Al-
– Retighten the nut again.
In case the angle indicator 49 is not in a line with
the 0° mark of the scale 50 after the adjust-
ment, the angle indicator must be aligned ac-
cordingly (see "Aligning the Angle Indicator
(Vertically)", page 66).
S1)
Setting the Standard Bevel Angle 45°
(Vertical)
– Bring the power tool into the table saw work-
– Turn the saw table 24 to the 0° detent 29.
S2)
– Release the clamping lever 38 and tilt the
ing position. (see "Working Position",
page 67)
The lever 28 must be felt to engage in the de-
tent.
T1)
on the saw table 24.
T2)
screw 59.
len wrench (size 3 mm) in or out until the leg
of the angle gauge is flush with the saw blade
over the complete length.
ing position. (see "Working Position",
page 67)
The lever 28 must be felt to engage in the de-
tent.
tool arm leftward to the stop (45°) by the
handle 20.
Bosch Power Tools