Safety Warnings For Use As A Chop And Mitre Saw; Safety Warnings For Use As A Table Saw - Bosch GTM 12 Professional Originalbetriebsanleitung

OBJ_BUCH-302-005.book Page 51 Tuesday, June 9, 2009 2:19 PM
Never make warning signs on the machine
unrecognisable.
Never stand on the power tool. Serious inju-
ries can occur when the power tool tips over
or when inadvertently coming into contact
with the saw blade.
Operate the power tool only when the work
area to the workpiece is clear of any adjust-
ing tools, wood chips, etc. Small pieces of
wood or other objects that come in contact
with the rotating saw blade can strike the op-
erator with high speed.
Operate the machine only for materials
mentioned under "Intended Use". Other-
wise, the machine can be subject to over-
load.
If the saw blade should become jammed or
when interrupting work, switch the saw off
and hold the workpiece until the saw blade
comes to a complete stop. Never attempt to
remove the workpiece as long as the saw
blade is in motion, otherwise kickback may
occur. Determine and correct the cause for
the jamming of the saw blade.
Do not use dull, cracked, bent or damaged
saw blades. Unsharpened or improperly set
saw blades produce narrow kerf causing ex-
cessive friction, blade binding and kickback.
Always use saw blades with correct size
and shape (diamond versus round) of arbor
holes. Saw blades that do not match the
mounting hardware of the saw will run ec-
centrically, causing loss of control.
Do not use high speed steel (HSS) saw
blades. Such saw blades can easily break.
Do not touch the saw blade after working
before it has cooled. The saw blade be-
comes very hot while working.
Do not direct the laser beam at persons or
animals and do not stare into the laser
beam yourself, not even from a distance.
This power tool produces laser class 2 laser
radiation according to EN 60825-1. This can
lead to persons being blinded.
Do not allow children unsupervised use of
the power tool with laser. They could blind
other people.
Bosch Power Tools
Do not replace the installed laser with an-
other laser type. A laser that does not fit to
this power tool could pose dangers for other
persons.
Safety Warnings for Use as a Chop and Mitre
Saw
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Make sure that the guard operates properly
and that it can move freely. Never lock the
guard in place when opened.
Keep hands away from the sawing area and
the saw blade. Danger of injury when coming
in contact with the saw blade.
Never remove cutting remainders, wood
chips, etc. from the sawing area while the
machine is running. Always guide the tool
arm back to the neutral position first and
then switch the machine off.
Guide the saw blade against the workpiece
only when the machine is switched on. Oth-
erwise there is damage of kickback, when
the saw blade becomes wedged in the work-
piece.
Always firmly clamp the piece to be
worked. Do not saw workpieces that are too
small to clamp. Otherwise, the clearance of
your hand to the rotating saw blade is too
small.
Never operate the machine without the in-
sert plate. Replace a defective insert plate.
Without flawless insert plates, injuries are
possible from the saw blade.

Safety Warnings for Use as a Table Saw

Make sure that the guard operates properly
and that it can move freely. It must face
against the table before sawing and against
the workpiece while sawing; never lock the
guard in place when opened.
Keep hands away from the sawing area and
the saw blade. Danger of injury when coming
in contact with the saw blade.
English | 51
1 609 929 U05 | (9.6.09)