Klarstein VALDOSTA 6.1 Bedienungsanleitung Seite 38

EN
38
• Do not tamper with any parts that have been sealed by the manufacturer or
its representative. Do not attempt to repair the device yourself. Repairs may
only be carried out by qualified specialist personnel.
• The gas grill should be serviced at least once a year by a qualified technician.
Do not attempt to service this device yourself.
• Before each use of the appliance, check for insects or insect nests in the
burner, pipes and appliance openings. Remove them, if present. Spiders and
small insects may nest in the pipes and unit openings when the unit is not in
use. This can block the flow of air and gas, causing a yellow flame to flash back
and cause a fire below the burner. Therefore, remove insects and insect nests
before each use, if present.
Gas requirements
Note: A gas pressure regulator approved according to EN 16129 and a gas hose
approved according to EN 16436-1 with a length of at least one metre must be
used for the appliance. If not included in the scope of delivery, these must be
purchased additionally.
• Contact your local gas cylinder dealer for the exact use of your gas cylinders.
• Never use a gas cylinder with a damaged tank, valve, base or ring.
• A deformed or rusted gas cylinder can be dangerous and should therefore be
checked for functionality by your local gas cylinder dealer before use.
• Never connect the appliance to a non-regulable gas source. Turn off the gas
when the appliance is not in use.
• The appliance may only be operated with propane or butane gas or a gas
mixture of both types of gas. The gas bottle must not be dropped or handled
roughly. The gas bottle must be disconnected when the grill is not in use. After
disconnecting, put the cap back on the gas bottle.
• Before connecting the gas bottle to the grill, make sure the gas valve is turned
off, there are no open flames near the appliance and the sealing ring is in
good condition. Then connect the pressure regulator to the gas bottle.
• The connection hose must be replaced every two years.
• Check the connection hose once a month and every time the gas cylinder is
changed. If the connection hose shows cracks or other signs of deterioration,
it must be replaced with a new one.
• If local regulations require it, the connection hose must be replaced.
• Make sure that the connection hose is not kinked or twisted and does not
come into contact with the surfaces of hot devices.
• Before changing the gas bottle, make sure that the gas has been turned off
and that there are no naked flames or other heat sources near the appliance.
Make sure the gas cylinder is always in an upright position.
• Only use the connections and accessories of the device for their intended
purposes.
• Do not turn the gas bottle upside down to use the remaining gas.
• Never ignite a gas barbecue with petrol or similar liquids.