Using Gryphon™ Bt Series Readers - Datalogic GRYPHON BT-Serie Kurzanleitung

UK/US
USING GRYPHON™ BT SERIES READERS
Gryphon™ BT series readers, together with a Bluetooth
device, build a Cordless Reading System for the collection, decoding and
transmission of barcoded data.
The Gryphon™ BT (Gryphon™ Bluetooth
scanner communicating in the 2.4 GHz ISM band and using the Serial Port
Profile (SPP). The Bluetooth
printer, etc with a built-in Bluetooth
(i.e. a Bluetooth
Using this Quick Reference Manual, you can initialize and start using
Gryphon™ BT reader with its default values. For details about general
configuration commands, refer to the Gryphon™ BT Refence Manual on
the configuration CD-ROM.
Gryphon™ BT readers automatically scan barcodes at a distance. Simply aim
the reader and pull the trigger. Code scanning is performed along the center of
the light bar emitted from the reading window. This bar must cover the entire
code.
READING ANGLE
Successful scanning is performed by tilting the reader with respect to the
barcode to avoid direct reflections which impair the reading performance, see
the figure below.
Successful reading is signaled by an audible tone plus a good-read blue spot.
Good read LED
To start using your Gryphon™ BT reading system you must:
1. Have a compatible remote Bluetooth
or an external Bluetooth
compatible device documentation.
2. Charge the Gryphon™ BT battery using C-GRYPHON charger as
described in this Quick Reference manual. A full charge takes 4 - 5 hours
with 1850mAH or 2100mAH NiMh batteries.
3. Configure the reader as described in this Quick Reference manual under
"Gryphon™ BT Configuration".
2
®
®
dongle).
Good read spot
OK
®
®
) reader is a CCD wireless barcode
compatible remote device can be a PC, PDA,
®
device or with external Bluetooth
®
device (with built-in Bluetooth
adapter) ready to work. See your Bluetooth
DATALOGIC
®
compatible remote
®
Not Advised
adapter
®
radio
®