Inserting The Batteries - Hama RC 660 Bedienungsanleitung

Warning – Batteries
• Never open, damage or swallow
batteries or allow them to enter the
environment. They can contain toxic,
environmentally harmful heavy metals.
• Immediately remove and dispose of
dead batteries from the product.
• Avoid storing, charging or using the
device in extreme temperatures and
extremely low atmospheric pressure (for
example, at high altitudes).
4. Getting Started
• Move the LOCK slide switch (12) to the
LOCK position to select normal mode.

4.1 Inserting the batteries

• Open the battery compartment (14),
insert three AAA batteries with the
correct polarity and close the battery
compartment (14).
5. Operation
Note
Immediate Hold down the 12/24/ YEAR
button (8), HOUR/ MONTH button (9) or
the MIN/ DATE button (10) to select the
values faster. ly remove and dispose of
dead batteries from the product.
5.1 Automatic date/time setting using
the DCF signal
• Once you have inserted the batteries, the
display is switched on, an acoustic signal
sounds and the alarm clock automatically
starts searching for a DCF radio signal.
During the search, the radio icon /
will ash. This process can take 3 to
5 minutes.
• When the wireless signal is received, the
date and time are automatically set.
4
Note – Time settings
• If, during initial setup of the device, no
DCF radio signal is received within the
rst few minutes, the search is aborted.
The radio icon will go out.
• If there are reception problems, we
recommend leaving the clock to
sit overnight, since interference is
generally less at night.
• In the meantime, you can start a
manual search for the DCF radio signal
at another location or you can manually
set the time and date.
5.2 Alarm
Setting the alarm time
• Move the LOCK slide switch (12) to the
ALARM SET position to manually set the
alarm time (2).
• Repeatedly press the 12/24/YEAR button
(8) to set the time of alarm 1 or alarm 2.
• Either the symbol or the
displayed accordingly.
• Set the hour by pressing the HOUR/
MONTH button (9).
• Set the minute by pressing the MIN/DATE
button (10).
• If necessary, press the 12/24/YEAR button
(8) again to set the other alarm.
• Move the LOCK slide switch (12) to the
LOCK position to save your settings and
return to normal mode.
• Repeatedly press the HOUR/MONTH
button (9) to display the set time of alarm
1 or alarm 2.
• The corresponding symbol (
displayed for about 10 seconds.
• By default, in normal mode (LOCK) the
time for alarm 1 is displayed.
symbol is
or ) is