Electrical Connection - DeLonghi Pinguino fx180 eco Betriebsanleitung

FX180eco 16-05-2002
Description of the remote control/
2
THE DISPLAY
Once the air-conditioner is turned on, all the
symbols will be shown.
When the appliance is turned off, only the
clock will remain visible.
A. Beep
Display of beef and start of the air-condi-
tioner; it also activates every time an ope-
ration is carried out.
B. Symbols
Air-conditioning, dehumidifying, ventila-
tion, heating (only on some models), Full
Auto.
C. Room temperature
Shows the room temperature.
D. Fan speed
Shows the various speeds: minimum,
medium, maximum, automatic and silent.
E. On/Off Timer
Shows the times programmed for turning
the appliance on and off.
F. Sleep/Silent Timer
Shows the function and the desired ope-
rating time, with the sleep function
G. Battery-replacement indicator
H. Air purification
The symbol remains on permanently
because when appliance is on, air is con-
tinuously filtered of impurities.
I. Set temperature
Shows the temperature set.
J. Clock
Shows the time.

ELECTRICAL CONNECTION

Before plugging in check that:
• the mains supply corresponds to the value shown in the specifications table;
• the socket and the mains lead correspond to the power requirements of the appliance;
• the socket is suited to the plug
• the socket is properly grounded. The manufactures cannot be held responsible for any dama-
ges due to failure in following normal safety procedures.
Replacement of the power cable must be carried out by qualified personnel.
If when selecting the air-conditioning function while concurrently there would be a decrease in
the voltage of the electrical current, a security device could intervene. This blocks the functioning
of the refrigerator circuit, in a way that the appliance operates as if it were in the ventilation/puri-
fication mode. In order to restore the air-conditioning function, you must turn off the appliance
and remove the plug from the outlet for at least thirty seconds. Then plug it back in.
24
14:53 Pagina 24
Electrical connection
10
, otherwise have the socket replaced;
BUTTONS
K. On / Off
L. MODE: Function selecting
This button selects the various functions:
air-conditioning, dehumidifying, Ventila-
tion/Purification, Heating (only on some
models) and Full Auto
M. Room thermostat
These two buttons select the desired room
temperature.
N. Room temperature display
Gives you the current room temperature.
After about four (4) seconds, the display
will show the temperature set previously.
O. Fan speed
Determines fan speed: minimum, medium,
maximum, automatic and silent.
P. SET: Clock and timer verification
Confirms the setting of the clock and the
ON/OFF timer.
Q. ON/OFF: programmazione timer
I tasti programmano lo spegnimento e
l'accensione del climatizzatore.
R. CANCEL: Timer
Cancels the setting on the ON/OFF timer.
S. RESET
T. ON / OFF: Timer programming
These buttons program the turning on and
off of the air-conditioner.
U. Sleep
This button controls the night-time opera-
tions.